anti black-out lamp, extractable torch for electric panels - 3 din
anti black-out lamp, extractable torch for electric panels - 3 din
2-MODULE extractable torch is equipped with high efficiency LED, that switches on when there is a powersupply voltage failure inside the electrical panel. Thanks to the possibility to be installed on DIN rail the maintenance is easier in case of power-supply voltage failure.
EXTRACTABLE
The torch may be extracted from its housing and used to give light to different places from where it is installed.
A practical switch placed on the front panel enables switching ON/switching OFF.
LED SIGNAL
The two Led signals (red and green) communicate the operation condition of the lamp:
Green: operative - battery charging and when there is a blackout, it activates safety lighting
Red: inhibited - battery charging and when there is a blackout, the torch remains off.
REPLACEABLE BATTERY
It is possible to replace the battery (supplied) by accessing easily at the side door of the device.
Power supply 230V AC ±15% 50 Hz
Light source 1 LED 0.5W 20 lumen
Autonomy in the event of a blackout approximately 2 hours
Maximum charging time 36 hours
Replaceable battery Ni-MH 3.6V - 140 mAh
Absorption 15 mA 3.5 VA
Protection degree IP30
Cable section with terminals 0.5..... 1.5 mm²
Pollution degree normal
Installation 2 civil modules in flush-mounted box
Operating temperature from 0°C to +40°C
Storage temperature from -10°C to +60°C
LVD/EMC marking standard EN60598-1,
EN60598-2-2, EN62471 55015:2006, EN61547
Dimensions (L x W x H) 38.5 x 60 x 90 mm